Sawing; Adjusting Nylon Line; Line Feed On Autocut Mowing Head; Line Feed On Supercut Mowing Head - Stihl FSA 130 Manual De Instrucciones

12 After Finishing Work

► Swing the brushcutter evenly back and forth in an arc (A).
If you are using a metal cutting attachment: Mow with the
left-hand side on the metal cutting attachment (B).
► Move forward slowly in a controlled manner.

11.4 Sawing

► Support the left side of the deflector against the stem.
► Cut through the stem at full speed.

11.5 Adjusting Nylon Line

11.5.1 Line Feed on AutoCut Mowing Head

► Tap the rotating mowing head on the ground.
About 30 mm of fresh nylon line is advanced. The line
limiting blade in the deflector trims the mowing lines to the
correct length.
2 1
0458-726-9821-C
Automatic feed does not operate if the mowing lines are
shorter than 25 mm.
► Switch off the trimmer and pull the connecting cable plug
out of the socket.
► Depress the spool (1) on the mowing head and hold it
depressed.
► Pull out the mowing lines (2).
► If the mowing lines (2) cannot be pulled out to the required
length: Replace the spool (1) or the mowing lines (2).
The spool is empty.

11.5.2 Line Feed on SuperCut Mowing Head

Mowing lines are advanced automatically. The line limiting
blade in the deflector trims the mowing lines to the correct
length.
Automatic feed will not take place if the mowing lines are
shorter than 40 mm.
► Switch off the trimmer and pull the connecting cable plug
out of the socket.
► Pull out the mowing lines.
► If the mowing lines cannot be pulled out to required length:
Replace nylon line.
The spool is empty.
12 After Finishing Work

12.1 When Work is Finished

► Switch off the brushcutter, move retaining latch to position
and pull the connecting cable plug out of the socket.
► If the brushcutter is wet: Allow the brushcutter to dry.
► Insert the plug in the socket.
► Clean the brushcutter.
► Clean the deflector.
► Clean the cutting attachment.
► If a metal cutting attachment is mounted: Fit the matching
transport guard.
English
57