Handling Electrical Cables; Target Group - Dometic COOLAIR RTX 1000 Instrucciones De Montaje

RTX1000/2000, SPX1200T
•
Please inform your vehicle manufacturer if the height entered in your vehicle
documents needs to be altered due to the installation of the parking cooler.
– RTX1000/2000 height: 175 mm
– SPX1200T height: 60 mm
•
Disconnect all power supply lines when working on the parking cooler
(cleaning, maintenance, etc).
2.2

Handling electrical cables

•
Use cable ducts to lay cables through walls with sharp edges.
•
Do not lay loose or bent cables next to electrically conductive materials
(metal).
•
Do not pull on the cables.
•
Attach and lay the cables in such a manner that they cannot be tripped over
or damaged.
•
The electrical power supply may only be connected by a specialist work-
shop.
•
The device shall be installed in accordance with national wiring regulations.
•
The connection to the vehicle's electrical system should be protected as
follows:
– power supply: 40 A
– voltage monitor: 2 A
•
Never lay power supply lines (battery leads) in the vicinity of signal or control
cables.
3

Target group

This installation manual contains the essential information and instructions for
installing the parking cooler. It is intended for competent installer technical staff
who are familiar with the guidelines and safety precautions to be applied when
installing lorry accessories.
This installation manual should always be kept with the unit to which it relates.
EN
Target group
5