SELF CLEAN OPERATION
SELF CLEAN operation will reduce the
growth mold fungus with Plasmacluster
ions and dry inside of the unit. Utilize the
operation at seasonal change over terms
1
Press the SELF CLEAN button when
the unit is not operating.
• The remote control will display "
• The green SELF CLEAN LAMP (
the blue PLASMACLUSTER lamp will light
up.
• The unit will stop operation after 40 min-
utes.
TO CANCEL
Press the SELF CLEAN button.
• The green SELF CLEAN LAMP (
the blue PLASMACLUSTER lamp will turn
off.
NOTE:
• You cannot set the temperature, fan speed, air
fl ow direction or timer setting during the SELF
CLEAN operation.
• Mold fungus already grown can not be
eliminated by this operation.
AY-XPC18LR_OM_ENG.indd 12
AY-XPC18LR_OM_ENG.indd 12
DISPLAY BUTTON
Press the DISPLAY button when the lamps
on the unit are too bright. (The red OPER-
ATION lamp and the orange TIMER lamp
.
cannot be turned off.)
1
During operation, press the DIS-
PLAY button.
".
• The blue PLASMACLUSTER lamp, the
green SELF CLEAN LAMP (
) and
the green FULL POWER lamp (
turn off.
TO LIGHT UP
Press the DISPLAY button again.
) and
AUXILIARY MODE
Use this mode when the remote control is
not available.
TO TURN ON
Press the AUX button.
• The red OPERATION lamp (
• The mode and the temperature setting are
automatically selected according to the room
temperature and the outdoor temperature
when the unit is turned on. The fan speed is
set to AUTO.
1
TO TURN OFF
Press the AUX button again.
• The red OPERATION lamp (
GB-12
) and/or
) will
1
) will light.
) will turn off.
AUX
2010-03-18 16:45:47
2010-03-18 16:45:47