Operation; Cleaning, Maintenance And Ordering Of Spare Parts - EINHELL TE-DW 18/225 Li Manual De Instrucciones

All 3 LEDs are lit:
The battery is fully charged.
2 or 1 LED(s) are lit:
The battery has an adequate remaining charge.
1 LED fl ashes:
The battery is empty, recharge the battery.
All LEDs blink:
The rechargeable battery has undergone ex-
haustive discharge and is defective. Do not use or
charge a defective rechargeable battery.

6. Operation

6.1 On/Off switch (Fig. 14/Item 1)
Switching on:
Push the unlocking/locking lever (j) forward and
press the On/Off switch (1).
Locking:
With the unlocking/locking lever (j) pressed, let go
of the On/Off switch (1)
Switching off :
Press the On/Off switch (1) briefl y and then let go.
6.2 Speed controller (Fig. 14/Item 2)
You can select the speed by turning the speed
controller (2).
Plus direction: Higher speed
Minus direction: Lower speed
6.3 Working with the drywall power sander
•
Place the whole surface area of the sanding
head on the material.
•
Switch on the machine and move it with
gentle pressure over the workpiece, making
circular or transverse and linear movements.
•
Use a coarse grit for coarse sanding and a
finer grit for finish sanding. You can find the
best grit size for the job by carrying out san-
ding tests.
Caution!
The dusts which are formed while the equipment
is being used may be a health hazard:
•
Always wear safety goggles and a dust mask
during sanding work.
•
All persons who work with the equipment or
enter the workplace must wear a protective
Anl_TE-DW_18-225_Li_SPK9.indb 22 Anl_TE-DW_18-225_Li_SPK9.indb 22
GB
dust mask.
•
Eating, drinking and smoking are prohibited
at the workplace.
•
Paints containing lead are not allowed to be
used!
6.4 Swiveling sanding head
The sanding head can be swiveled in two axes,
enabling comfortable sanding even overhead and
in tight spaces.
7. Cleaning, maintenance and
ordering spare parts
Hazard!
Always pull out the battery pack before starting
any cleaning work.
7.1 Cleaning
•
Keep all safety devices, air vents and the
motor housing free of dirt and dust as far as
possible. Wipe the equipment with a clean
cloth or blow it with compressed air at low
pressure.
•
We recommend that you clean the device
immediately each time you have finished
using it.
•
Clean the equipment regularly with a moist
cloth and some soft soap. Do not use
cleaning agents or solvents; these could at-
tack the plastic parts of the equipment. Ensu-
re that no water can seep into the device. The
ingress of water into an electric tool increases
the risk of an electric shock.
7.2 Maintenance
There are no parts inside the equipment which
require additional maintenance.
7.3 Ordering spare parts and accessories
Please provide the following information when
ordering spare parts:
•
Type of unit
•
Article number of the unit
•
ID number of the unit
•
Spare part number of the required spare part
For our latest prices and information please go to
www.isc-gmbh.info
- 22 -
06.07.2020 06:13:28 06.07.2020 06:13:28