Settings; Working - Festool CLEANTEX Serie Manual De Instrucciones

CLEANTEX
GB
6.2 Switch on/off
X
Insert the plug into an earthed socket.
WARNING
Risk of injury from tools starting up un-
expectedly
X
Before setting the switch to the "AUTO" or
"MAN" position, make sure that the con-
nected tool is switched off.
The switch [1-7] serves as an on/off switch.
Switch position "0"
Appliance socket [1-3]
the power, mobile dust extractor is switched
off.
"MAN" switch position
Appliance socket [1-3]
power, the mobile dust extractor starts.
"Auto" switch position
Appliance socket [1-3]
power, the mobile dust extractor starts when
the connected tool is switched on.
7

Settings

7.1 Connecting electric power tools
WARNING
Risk of injury
X Observe the maximum connected loads
for the appliance socket (see chapter
"Technical data").
X Make sure that the power tool is switched
off before connecting or disconnecting.
X
Connect the electric power tool to the ap-
pliance socket [1-3].
7.2 Connecting pneumatic tools
WARNING
Risk of injury
X Make sure that the pneumatic tool is
switched off before connecting or discon-
necting.
If the compressed air module
is installed, the automatic switch-on function
of the mobile dust extractor also works in
combination with pneumatic tools.
14
is disconnected from
is connected to the
is connected to the
[1-2] (496141)
We also recommend installing the VE service
unit (495886). The service unit filters and lu-
bricates the compressed air and enables an
adjustment of the air pressure. An IAS
adapter (454757) is available to connect Fes-
tool pneumatic tools to the IAS system.
The operating pressure of the tool must be
6 bar for the automatic switch-on unit to
function correctly.
7.3 Adjusting the suction power
You can use the suction power adjuster
to adapt the machine suction power to differ-
ent applications.
7.4 Applying the brake
Folding out the black brake lever
vents the mobile dust extractor from rolling.
To achieve this, lift the front end of the mo-
bile dust extractor slightly and push the
black brake lever downwards until it latches
into place. Push the green lever
to release.
7.5 Temperature cut-out
To prevent overheating, a temperature cut-
out switches the mobile dust extractor off
when it reaches a critical temperature.
X
Switch off the mobile dust extractor and
allow to cool for about 5 minutes.
L If the mobile dust extractor will not switch
on again, please contact a Festool service
workshop.
8

Working

8.1 Handling
Hose store: after finishing work, you can
feed the suction hose through the recess
3] and place it in the hose store. You can do
the same with the mains cable through the
other recess [4-2].
SysDoc Systainer attachment system: a
Systainer can be attached to the storage
area via the two slides [4-1].
8.2 Extracting dry materials
The filter element will become damp when
fluids are extracted. A damp filter element
will clog more quickly when dry materials are
extracted. Therefore, dry the filter element
before extracting dust or replace the damp
filter with a dry one.
8.3 Extracting fluids
Before extracting fluids, remove the filter or
disposal bag (see chapter 9.1). We recom-
mend using a special wet filter.
[1-8]
[1-12] pre-
[1-11] again
[4-