Settings; Working; Extracting Dry Materials; Temperature Cut-Out - Festool CT MINI I HEPA Manual De Instrucciones Original

Switching on/off
Once the remote control is connected to the
mobile dust extractor, the mobile dust extractor
can be switched on and off with the remote con­
trol.
► Press the MAN button on the remote con­
trol to switch the device on and off.
Resetting the remote control
Resetting deletes the connection between a re­
mote control and the mobile dust extractor.
► Hold down the connection button and the
MAN button for 10 seconds.
The LED indicator lights up purple, if the re­
set has taken place.
7.7 Delete all saved devices. (MINI I / MIDI
I)
► Press and hold the connection button [1-20]
for at least three seconds.
The connection display [1-19] flashes rapid­
ly.
► Press and hold both the plus and minus
button [1-18] for at least three seconds.
The mobile dust extractor confirms the com­
mand by rapidly flashing three times.
8

Settings

8.1 Adjusting the suction power
► Press the plus or minus button [1-18] while
extracting.
8.2

Temperature cut-out

A temperature cut-out switches the mobile dust
extractor off when it reaches a critical tempera­
ture to prevent overheating. The bottom
LED [1-18] indicates a fault.
LED lights up red
► Switch off the mobile dust extractor, let it
cool down.
► Switch on the mobile dust extractor again
after approx. five minutes.
8.3 Locking the brake [1A]
► Raise the front of the mobile dust extractor
slightly.
► Push down the brake [1-13] until it engages
into position.
► Actuate the button [1-12] to release it.
Excessive temperature
1-12
1-13
8.4 SysDoc
WARNING
Risk of injury
► Do not stand on the storage area of the
mobile dust extractor.
CAUTION
Risk of injury
► Ensure that the T-Loc or the four SysDoc
locks are closed during transport.
A Systainer can be fastened to the storage
area [1-7] with the T-Loc lock [1-8]. Systainers
without T-Loc can be secured with the four Sys­
Doc locks [1-3].
9

Working

9.1

Extracting dry materials

CAUTION
Hazardous dust
Damage to the respiratory passage
► Always use a filter bag!
CAUTION
Hazardous dust
Damage to the respiratory passage
► Check that the main filter is undamaged
before extracting.
When extracting dust that exceeds the
limit value, only extract from one dust
source (power or compressed-air tool).
Observe the following when extracting dust
generated by operating power tools:
Ensure there is adequate ventilation! Observe
regional regulations!
Limit values: Exhaust air max. 50% of the fresh
air volume
Equation: room volume V
English
x air renewal rate L
R
13
W