Connecting A Mobile Device; Settings - Festool CTLC MINI I Manual De Instrucciones

Connecting a new power tool overwrites
the previous connection.
This function is only possible on Festool
power tools with a Bluetooth
pack.
9.2 Connecting the CT-F I remote control
To be able to connect a remote control to a
cordless mobile dust extractor, the remote con­
trol must be reset (see "Reset on the remote
control").
Remote controls that have not been connected
previously can be connected directly.
A connection that has been created be­
tween remote controls and the cordless
mobile dust extractor will persist even af­
ter pressing the on/off button or removing
a battery pack (from the cordless mobile
dust extractor).
The cordless mobile dust extractor can be
connected to as many as five remote con­
trols at the same time. The cordless mo­
bile dust extractor can only be connected
to one battery-powered power tool at a
time.
If a cordless mobile dust extractor which
was initially switched on using the battery
pack is switched off using the remote con­
trol, the temporary connection between
the connected battery pack and the cord­
less mobile dust extractor will be lost. The
battery pack can then be connected again.
► Hold down the connection button [1-16] on
the cordless mobile dust extractor for three
seconds in standby mode.
The connection display [1-17] rapidly flashes
blue. For a period of 60 seconds, the cordless
mobile dust extractor is ready for connection.
► Press the MAN button [1-21] on the remote
control.
The remote control is permanently stored in the
cordless mobile dust extractor.
Resetting on the remote control
Resetting deletes the connection between a re­
mote control and the cordless mobile dust ex­
tractor.
► Press and hold the connection button [1-19]
and the MAN button [1-21] for 10 seconds.
The LED indicator [1-20] lights up purple, if the
reset has taken place.
9.3
The cordless mobile dust extractor can be con­
nected to a mobile device (e.g. for a software
update) using the Festool Work app.
® battery
► Hold down the connection button [1-16] on
The connection display [1-17] rapidly flashes
blue. For a period of 60 seconds, the cordless
mobile dust extractor is ready for connection.
► Follow the instructions provided in the

10 Settings

10.1 Adjusting the suction power
► Press the plus or minus button for the suc­
The green LEDs on the status display [1-15] in­
dicate the current performance level.
10.2 Connecting sleeve
The bypass function of the connecting
sleeve [3-1] prevents strong suction from
sanding machines and floor nozzles on smooth
surfaces.
Open
► Turn the adjusting ring to the "OPEN" posi­
Close
► Turn the adjusting ring to the "CLOSE" posi­
10.3 Volumetric flow monitoring (only for
Hazardous dust
Damage to the respiratory passage
► Correct functioning of volumetric flow
For safety reasons, an acoustic warning signal
sounds if the air speed in the suction hose falls
below 20 m/s.

Connecting a mobile device

the cordless mobile dust extractor for three
seconds in standby mode.
Festool Work app to authorise the secure
connection.
tion power adjustment [1-14] while extract­
ing.
tion.
tion.
dust class M)
CAUTION
monitoring is only ensured with the suction
hose D 27/32x3.5m-AS/CTR.
English
23