Options - Seat - Breezy RelaX2 Manual De Usuario

Options – Lap belt
When fastened check space
between the lap belt and user,
when correctly adjusted it should
not be possible to insert more than
the flat of the hand between the lap
belt and the user. (Fig. 26)
Generally the Lap Belt should be fixed so that the
straps sit at an angle of approximately 45°, and
when correctly adjusted should not allow user to
slip down in the seat.
(Fig. 27)
To fasten buckle:
Firmly push male buckle into
female buckle.
Advice to client
Do not rely on the lap belt only when the wheelchair
and occupant are transported in a vehicle, use the
separate occupant lap and diagonal restraints provided
in the vehicle.
Before use we recommend that the lap belt be checked to
ensure that it is adjusted correctly, free from any obstruction or
adverse wear and that the buckle engages securely.
Failure to make sure that the lap belt is secure and
adjusted prior to use could cause serious injury to the
user. e.g. too loose a strap may allow the user to slip
down in the chair and risk suffocation.
Maintenance:
Check lap belt, and securing components; at regular
intervals for any sign of fraying or damage. Replace if
necessary.
Clean the lap belt with warm soapy water and allow it to dry.
NOTE:
The lap belt should be adjusted to suit the end user as detailed
above
Sunrise Medical also recommend that the length and fit of the belt is
checked on a regular basis to reduce the risk of the end user
inadvertently re-adjusting the belt to an excessive length
If in doubt about the use and operation of the seat belt
then ask your healthcare professional, wheelchair
dealer, carer or attendant for assistance.
12
Fig. 26
Fig. 27
To release belt:
Press exposed sides of male
buckle and push towards centre
/ push the press button of the
female buckle whilst gently pull-
ing apart.

Options - Seat

Comfort seat
The comfort seat is an anatomi-
cally shaped cushion and offers
comfortable seating over a long
period of time.
The cushion is held by Velcro and
can also be removed. The cover
can be washed (see the instruc-
tions on the cushion).
Seat depth
Fig. 29
After loosening (a 360°
turn) the screws (1), you
can set the seat depth
to the desired position.
Then tighten the screws
again (see the page on
torque).
CAUTION!
The maximum seat depth (see marking and endstop) must not
be exceeded.
Seat width adjustment
You can extend the width of the seat of your wheelchair by removing
the inner pads or add spacers (see option sideguard)
Adjustable seat angle
(0°-25° / -3 -22°)
By pulling the lever (1) the seat is
released and can be put into the
desired position. When you let go,
the seat is automatically fixed in the
new position.
CAUTION:
The angle-adjustable seat may
only be used with anti-tip tubes.
CAUTION:
To ensure the correct function of the cables, these must never
be taut.
CAUTION:
There is a danger of trapping your fingers when you adjusting
the seat.
CAUTION:
Never adjust the seat angle if the wheelchair is on a slope.
Option Abduction
By loosening the screw (1) the
abduction wedge can be adjusted
height-wise and by loosening the
screws (2, ) it can be adjusted
depth-wise or removed.
Fig. 28
1
Fig. 30
Fig. 31
2
1
1