Step 3: Settings; Turning On The Unit - Sony NSR-500 Serie Manual De Instalación

3
Connect the NSR to the UPS with the
dedicated serial cable to the
RS-232C 1 (UPS) connector on the
rear of the NSR.
Power cord
UPS
Connecting an Audio Output
Device
Connect the audio output device to the line
output connector.
Audio cable
24

Step 3: Settings

Serial cable
To Power source
Step 3: Settings
This section provides information on how
to turn on the unit, and general explanations
on how to register cameras and other
devices.

Turning On the Unit

When you press the power switch on the
front panel of the unit, the unit turns on and
the POWER LED on the front panel lights
green.
When you turn on the unit for the first time,
the Setup Wizard starts automatically.
Continue to the following section,
"Configuring Initial Settings with Setup
Wizard."
Notes
• The fan noise may be loud after turning
on the unit. This is not a malfunction.
• If a forced shutdown was performed
previously, the unit may take longer to
start up.
To turn off the unit
After logging on to NSR, click
top of the "Main" screen, and select
[Shutdown] from the menu that appears.
at the