Registering Cameras - Sony NSR-500 Serie Manual De Instalación

Notes
• For details on licenses, refer to the
NSBK-CL05 Installation Guide (PDF).
• For details on acquiring licenses, contact
your Sony dealer.
Logging On
Enter the user name and password, and
click [Logon].
Default user name: admin
Default password: admin
r
When logon is successful, the Camera Auto
Registration dialog appears.
Notes
• Only Sony cameras will be located and
registered.
• Only cameras with IP address settings
that have not been changed from factory
default conditions will be located and
registered. To register cameras with IP
addresses that have been changed, use
[Easy Setup] (page 29), or return the
camera IP address settings to default
conditions and restart the unit.
• If you want to manually specify cameras
for registration, click [No] and proceed to
the next section, "Registering Cameras."
• If you select the [Do not show this dialog
box again] check box, this dialog box will
not appear on subsequent startup of the
software, and cameras will not be
located. If you selected this check box
previously and want to perform
automatic camera registration again later,
configure settings in the [Administration
Menu] to reenable display of this dialog
box. For details on the [Administration
Menu], refer to the User's Guide (PDF).

Registering Cameras

You can register cameras using one of the
following methods: register cameras using
Easy Setup; select cameras that were
automatically detected and then register
them simultaneously; or register devices
manually.
Registration using Easy Setup
Follow the instructions of the wizard to
configure each setting.
1
Select [Easy Setup], and click [Next].
The Easy Setup wizard appears.
2
Register the cameras.
If you do not want to register cameras,
select [Skip configuration] and click
[Next], and proceed to step 3.
1 Select [Configure], and click
[Next].
Step 3: Settings 29