Environmental Protection; Technical Specifications - Metabo W 750-115 Instrucciones De Manejo

10. Repairs
Repairs to electrical tools must ONLY be
carried out by qualified electricians!
Contact your local Metabo representative if you
have Metabo power tools requiring repairs. See
www.metabo.com for addresses.
You can download a list of spare parts from
www.metabo.com.

11. Environmental Protection

The sanding dust generated may contain
hazardous materials: do not dispose of dust with
household waste, but at a special collection point
for hazardous waste.
Observe national regulations on environmentally
compatible disposal and on the recycling of disused
machines, packaging and accessories.

12. Technical Specifications

Explanatory notes on the specifications on page 3.
Subject to change in accordance with technical
progress.
Ø = max. diameter of the accessory
t = max. permitted thickness of the clamping
max,1
shank on accessory when using two-hole
nut (10)
t = max. permitted thickness of clamping
max,3
shank on accessory when using (tool-
free) clamping nut (12)
t = roughing disc/cutting disc:
max,4
max. permitted thickness of accessory
M = Spindle thread
l = Length of the sanding spindle
n* = No-load speed (maximum speed)
P = Rated input power
1
P = Power output
2
I = Current at 120 V
120 V
m = Weight without mains cable
The technical specifications quoted are subject to
tolerances (in compliance with relevant valid
standards).
Emission values
These values make it possible to assess the
emissions from the power tool and to compare
different power tools. The actual load may be higher
or lower depending on operating conditions, the
condition of the power tool or the accessories used.
Please allow for breaks and periods when the load
is lower for assessment purposes. Arrange
protective measures for the user, such as
organisational measures based on the adjusted
estimates.
Total vibration value (vector sum of three directions)
determined in accordance with EN 60745:
a = Vibration emission value
h, SG
(surface grinding)
a = Vibration emission value
h, DS
(sanding with sanding plate)
K = Uncertainty (vibration)
h,SG/DS
Typical A-effective perceived sound levels:
L = Sound-pressure level
pa
L = Acoustic power level
WA
K , K = Uncertainty
pA WA
Wear ear protectors!
ENGLISH en
11