Spot Cleaning Mode - ECOVACS ROBOTICS DEEBOT R95 Manual De Instrucciones

3. Operating and Programming
2

Spot Cleaning Mode

This mode is applicable for an area of highly concentrated dirt or dust. In Spot Cleaning Mode,
DEEBOT focuses on a specific area to clean and returns to the Charging Dock once the Spot
Cleaning is completed.
To start Spot Mode Cleaning, press
spot and a 1m/3.2' area around the spot.
3
Area Cleaning Mode
After DEEBOT has scanned and mapped the environment, specific areas on the map can be selected
to be cleaned using Area Cleaning Mode. Area Cleaning Mode can only be selected using the App.
To set or discard cleaning areas, press
* DEEBOT can only recognize a room with doorway ranging from 40cm (1.3') to 160cm (5.2')
and perimeter larger than 8m (26.2').
4 Return to Charger Mode
When battery power gets low, DEEBOT
automatically switches to Return to Charger
Mode and returns to the Charging Dock to
recharge itself.
DEEBOT can also be sent back to the Charging
Dock at any time by pressing the Return to
Charger Mode Button on the main screen of the
ECOVACS App.
* After pressing the Return to Charger Mode Button on the App's main screen, DEEBOT will
continue cleaning until it gets close to the Charging Dock. Once it is near the Charging Dock,
DEEBOT reduces power and gently dock itself to recharge.
14
EN
on the App's map screen. DEEBOT cleans the selected
on the App's map screen.