Troubleshooting Guide - Blaupunkt Sacramento CD33 Instrucciones De Manejo E Instalación

Troubleshooting Guide

The following check will assist in the correction of most prob-
lems which you may encounter with your unit. Before going
through the check list below, refer back to the connection and
operating procedures.
General
Trouble Cause/Solution
• Memorized stations and Leads are not matched
correct time are erased. correctly with the car's
• The fuse has blown. accessory power
• Radio works when the igni- connector.
tion key is the ON, ACC and
Check wiring for short
OFF positions.
circuits.
• No power is being supplied
to the unit.
• The power is continuously
The car doesn't have an
supplied to the unit.
ACC position.
Radio reception
Trouble Cause/Solution
Preset stations are not re-
The broadcast signal is too
ceivable.
weak.
Seek tuning is not possible The broadcast signal is too
weak. → Use manual tuning.
Travel Store feature does Not enough broadcast frequen-
not complete storing of six cies are receivable.
stations.
Also make sure that antenna is connected, extended and dry
inside.
If the above mentioned solutions do not help to improve the
situation, consult your nearest Blaupunkt dealer or in the
United States call 1-800-266-2528 for technical assistance,
parts and service. Call 1-800-950-2528 for dealer referral or
to request product brochure.
SacramentoCD33_Eng 15
CD Player Troubleshooting
When problems occur with CD playback, an error message
appears in the display window.
Refer to the table below to identify the problem, then take the
suggested corrective action. If the error persists, contact your
nearest Blaupunkt dealer.
Message Possible cause Recommended action
Dirty disc. Clean the disc.
FOCUS
Scrached disc. Replace the disc.
ERR
Up-side-down. Check the disc.
SERVO
Data and focus error. Eject and re-insert.
ERR
MECHA
Mchanical problem. Eject and re-insert.
ERR
The disc cannot Eject and re-insert. In-
TOC ERR
read properly. sert anothert disc.
You can not play a CD-
DATA Plays the data track
TRACK of MIX mode CD or ROM. Skip the music
track with TUN/TRK dial.
CD-ROM.
CD Changer Troubleshooting
When problems should develop while operating CD changer,
an error message appears in the display window.
Refer to the table below to identify the problem, then take the
suggested corrective action. If the error persists or "MECHA
ERR" and "09 ERROR" appears, contact your nearest
Blaupunkt dealer.
Message Possible cause Recommended action
NO MAG No magazine. Load the magazine in
No disc. the CD changer.
NO DISC
Check the disc.
Up-side-down.
CD ERR Check the disc.
Focus error.
COMM ERR Communication error. Check the connection of
the CD changer.
TEMP ERR Excessive tempera- The error sign will go off
ture conditions at and play will resume
the CD changer. when the temperature to
a normal range.
2/5/03, 4:28 PM
Specifications
GENERAL
Dimensions : Approx. 178 mm × 50 mm × 155 mm
(W × H × D) *excluding Front panel.
Power requirements : 12 volts DC car battery
(negative ground)
Output Power : RMS and Peak Power ratings
(188watts)
220 watts /55 peak × 4 ch
Output Wiring : Floating-ground type designed for 4
speaker use.
RCA low-level outputs (2 channels).
Output Impedance : Compatible with 4-8 ohm speakers.
Low - Level Output : 2 V.
TUNER
Tuning Range : AM : 530 - 1,710 kHz (10 kHz step)
FM : 87.5 - 107.9 MHz (200 kHz step)
Sensitivity : AM : 20 µV
FM : 9.1 dBf mono sensitivity
FM
Stereo Separation : 35 dB
CD PLAYER
Frequency
Response : 20 - 20,000 Hz
S/N Ratio : 98 dB
Wow & Flutter : Below the measurable limit
OTHER
Remote Control options : RC-823 Credit Card Remote
CD Changer cable : p/n F00E500029
AUX input cable : p/n 7 607 897 093
E-15