Blaupunkt Sacramento CD33 Instrucciones De Manejo E Instalación página 7

Turn on/off message edit
You can edit the turn on/off message and store it in memory.
Following four messages can be edit with 8 characters each.
Turn-on message
• HELLO (MESG 1) / WELCOME (MESG 2)
Turn-off message
• SEE YOU (MESG 3) / GOOD-BYE (MESG 4)
1.
Repeatedly press the DISP to display the "MESG ON" on
the display window.
2.
Press the SC/PS to flash the "HELLO".
3.
Rotate the VOL dial to select the desired message you
want to edit.
HELLO ➜ WELCOME ➜ SEE YOU ➜ GOOD- BYE
4.
Press the , then enter the character.
SC/PS
A. Rotate the VOL dial in a clockwise direction to select
the desired characters.
< > ∗ + −
( A ➜ B ➜ C ➜ . . . Z ➜ ➜ ➜ ➜ ➜ ➜
'
➜0➜1➜2➜3...9➜" "Space )
B. Rotate the TUN/TRK dial to move the flashing cur-
sor.
C. Repeat steps A. and B. to complete entering the en-
tire message 8 characters max.
Tips
• To erase /correct a message, press the for more than
DISP
2 seconds to clear the character and re-enter.
• If you make no button input or dial operation in 20 sec-
onds, the message edit mode will turn off automatically.
• Make sure the "MESG" will be "ON" .
• When entering a name, pressing the following buttons af-
fects the display of characters as follows.
: Changes to inputting letters. (Starts with "A".)
1
0
: Changes to inputting numbers. (Starts with "
2
: Changes to inputting characters. (Starts with "
3
: Enters a space (blank).
6
5.
Press the to store the message.
SC/PS
The new message flashes.
6.
To return to the normal radio reception, Press DISP
E-6
SacramentoCD33_Eng 6
Erasing the turn on/off message
You can erase the turn on/off message if so desired.
1.
Repeatedly press the to display the "MESG ON"
DISP
on the display window.
2.
Press the , then rotate the VOL dial to select the
SC/PS
desired message you want to erase.
3.
Press the SC/PS , then press the
DISP
seconds.
4.
To return to the normal radio reception, Press
Repeat steps 2. and 3. if you want to erase other mes-
sage.
' /
➜ ➜
".)
<
".)
.
for more than 2
.
DISP
2/5/03, 4:27 PM