STERWINS 1100 JET IC-3 Instrucciones De Montaje página 199

• Do not use any sharp tool (cutter, knife...) when unboxing, you
may damage the product.
• When unboxing, take the pump with the carrying handle (11)
• Do not use any sharp tool (cutter, knife...) when unboxing, you may damage the
product.
• Do not use the power cord to lift, carry or transport the
• When unboxing, take the pump with the carrying handle (7)
machine.
• Do not use the power cord to lift, carry or transport the machine.
• Do not scrape the power cord across sharp edges and ensure
• Do not scrape the power cord across sharp edges and ensure that it does not get
that it does not get pressed.
pressed.
4.2 INSTALLATION
4.2 INSTALLATION
Tightly screw the pump
Tightly screw the pump
Attach the pump to a flat level surface with suitable screws and silent block if necessary.
DANGER! Risk of injury due to electric shock.
DANGER! Risk of injury due to electric shock.
Warning! Do not plug in before installation is fully completed !
Warning! Do not plug in before installation is fully completed !
CAUTION ! Always wear safety glasses and gloves during
installation.
CAUTION ! Always wear safety glasses and gloves during
installation.
Intlet connection illustration
Suction hose illustration 2.3
it with appropriate tool.
Assemble the different elements together according to the illustration. In case screw are necessary : tight
• As a basic principle, we recommend using:
it with appropriate tool.
• As a basic principle, we recommend using:
foreign bodies.
- A preliminary filter, in order to avoid unnecessary damage to the pump as a result of stones and solid
- A suction-hose set with suction hose and an intake valve with a strainer (in order to prevent long
foreign bodies.
priming periods).
- A suction-hose set with suction hose and an check valve with a strainer (in order to prevent long
• If you cannot obtain a suction-hose set, please purchase :
priming periods).
- an 25 mm (1") intake hose
• If you cannot obtain a suction-hose set, please purchase :
- an intake valve with a strainer
- an 25 mm (1") intake hose
- 2 hose clamps 2 standard adapters (one for the intake line, one for the discharge line) and assemble the
- a check valve with a strainer
suction-hose set yourself using a standard adapter and a clamp et un collier de serrage.
- 2 hose clamps 2 standard adapters (one for the suction hose, one for the discharge line) and assemble
the suction-hose set yourself using a standard adapter and a clamp.
Attach the filter to the wall. Make sure that the vibrations of the pump do not damage this
4.3 FIRST USE
installation (flexible connection is strongly recommended)
4.3 FIRST USE
WARNING ! Read the « SAFETY INSTRUCTION » section at the
beginning of this manual including all text under subheading
WARNING ! Read the « SAFETY INSTRUCTION » section at the
therein before using this product.
beginning of this manual including all text under subheading
therein before using this product.
Pay particular attention using the machine for the first time : focus and dedicate all your attention to this
Setting up your pump
first use.
Setting up your pump
• Remove the connectors caps from the connectors and store them.
• Place the pump on flat firm surface to ensure safe operation.
• Remove the connectors caps from the connectors and store them.
Connecting the suction hose
• Screw the standard connectors onto the suction connector.
illustration 2.2
illustration 2.2
12
199
FR FR
ES ES
PT PT
IT IT
EL EL
PL PL
RU RU
KZ KZ
FR
UA UA
ES
RO RO
PT
EN
EN
IT
EL
PL
RU
KZ
UA
RO
EN