Store The Machine - STERWINS 1100 JET IC-3 Instrucciones De Montaje

IT
FR
EL
5. TRANSPORTATION
ES
PL 5.1 TRANSPORT THE MACHINE
PT
RU
IT
KZ
Always lift and carry the pump with the carrying handle. Protect the product from any heavy impact
EL
UA
or strong vibrations which may occur during transportation in vehicles. If you want to transport the
appliance on a vehicle secure it from slipping or vibrating. Secure the product to prevent it from slipping
or falling over.
PL
RO
6. WINTERING
RU
EN
Illustration 5.1 to 5.3
Switch o and empty the pump.
KZ
Follow all instructions given on chapter storage below.
7. STORAGE
UA

7.1 STORE THE MACHINE

RO
The instructions mentioned in the maintenance section must be carried out before any storage.
Illustration 5.1 to 5.3
EN
• Completely drain the pump, allow it to dry and put back the two connector caps.
• Clean the product, filters and accessories
• Store the unit and its accessories in a frost-free place.
• The unit should always be stored in a clean, dry, ventilated place out of the reach of children. Ideally, the
temperature of the room in which the device is stored should be between 4 and 24°C.
• We recommend that you store the unit in an upright position, in its original package.
8. MAINTENANCE
8.1 CLEANING
Illustration 4.1 to 4.6
1. Disconnect the pump
2. Unscrew the discharge connection
3. Clean the discharge part of the pump with clean water
4. Check the integrity of the electrical cable.
8.2 SERVICE
• Have your product serviced by a qualified repair person using only identical replacement parts. This will
ensure that the safety of the product is maintained.
• Have the product checked by a qualified professional and repaired, if necessary, before you use it again.
to "Troubleshooting" chapter.
• Restart : To restart the pump after resolving a failure, reset the pressure control
unit by pressing this button.
CAUTION In order to prevent accidents or injuries,
keep in mind the weight of the appliance during transport
(see Technical Data).
or serious injury. Switch the product before adjusting,
inspecting, cleaning or storing the product.
16
202