Specific Functions - STERWINS 1100 JET IC-3 Instrucciones De Montaje

Connecting the discharge hose
For automatism and discharge hose installation, please refer to the illustration.
A hose with a diameter of 25MM is recommended for better results.
4.4 OPERATION
Start the pump illustration 3.1 to 3.3
Make sure the pump is correctly installed and primed, refer to chapter "first use" above.
Connect the power cable to an earthed 220-240V 50Hz power supply protected by a minimum 10-amp
fuse. Press the ON/OFF switch. The switch light will come on when the motor is running. Once the pump
has been primed, put the discharge hose back down.
Operation safety warnings
• Operate the product only at reasonable hours – not early in the
morning or late at night when people might be disturbed.
• Do not modify the product in any way or use parts and
accessories that are not recommended by the manufacturer.
to vibrate abnormally, immediately stop the product and
inspect for damage or identify the cause of the vibration.
Any damage should be properly repaired or replace by an
authorized service center.
Operate the pump
• In order to prevent dry-running and overheating of the machine, always make sure that the suction
hose is immersed under water.
• The motor is protected against overheating by an integrated thermostat. In the event of overheating,
the thermostat will automatically switch
cooled down.
Stop the pump
• To reduce the risk of injury, always stop the machine :
- before cleaning or clearing a blockage
- before installing or removing attachments
- before checking, maintaining or working on the product
- if the machine starts to vibrate abnormally (inspect
immediately).

4.5 SPECIFIC FUNCTIONS

illustration 2.8
14
the pump. The pump will automatically restart after it has
fic
201
FR
ES
PT
IT
EL
PL
RU
FR
KZ
ES
UA
PT
RO
IT
EN
EL
PL
RU
KZ
UA
RO
EN