Connecting To Power Supply; Switching On - Stihl FSE 31 Manual De Instrucciones

Ocultar thumbs Ver también para FSE 31:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 63

Connecting to Power Supply

The voltage and frequency of the
machine (see rating plate) must match
the voltage and frequency of the power
connection.
The minimum fuse protection of the
power connection must comply with the
specifications – see "Specifications".
The machine must be connected to the
power supply via an earth-leakage
circuit breaker to disconnect the power
supply if the differential current to earth
exceeds 30 mA.
The power connection must correspond
to IEC 60364 and relevant national
regulations.
Depending on the supply voltage and
cord length, the minimum conductor
cross section of the extension cord must
be as follows:
Cord length
Minimum cross
section
220 V – 240 V:
up to 20 m
1.5 mm
20 m to 50 m
2.5 mm
100 V – 127 V:
up to 10 m
AWG 14 / 2.0 mm
10 m to 30 m
AWG 12 / 3.5 mm
FSE 31, FSE 41
Insert the appliance plug (1) into the
N
extension cord coupling (2).
Strain Relief (Cord Retainer)
Make a loop in the extension cord.
N
Pass the loop (3) through the
N
opening (4).
2
Slip the loop (3) over the hook (5)
N
2
and pull it tight.
Connect the extension cord plug to
N
2
a properly installed wall outlet.
2

Switching On

1
2
N
N
4
5
3
N
N
N
1
Make sure you have a secure and
balanced footing.
Hold your trimmer with both hands –
right hand on the control handle –
left hand on the assist handle.
Stand upright – hold the trimmer in a
relaxed position and always on right
side of your body.
Make sure the cutting attachment is
not touching the ground or any other
objects.
Squeeze the trigger switch (1).
English
31

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Fse 41

Tabla de contenido