Fitting The Harness; Starting; Connecting To Power Supply - Stihl FSE 60 Manual De Instrucciones

If the nylon lines are shorter than 1"
(2.5 cm):
: Switch off the machine.
: Unplug the power cord from the
power supply.
: Turn the machine in its back.
: Push home button on the spool as
far as stop.
: Pull the ends of the nylon lines out
of the spool.
If the spool is empty, fit fresh nylon line –
see "Replacing the Nylon Line".
Removing the Mowing Head
STIHL AutoCut
: Hold the spool housing firmly.
: Rotae the cap counterclockwise.
Fitting New Nylon Line
STIHL AutoCut
see chapter on "Replacing Nylon line".
FSE 60

Fitting the Harness

A Harness is available as special
accessory.
Wear the harness over your left shoulder
and adjust its length so that the spring
hook lies against your right hip.
The open side of the hook should face
away from your body. Attach the spring
hook to the carrying loop.
English / USA

Starting

1 2

Connecting to power supply

The voltage of your power supply and
the voltage specified on the unit must be
the same. Use an extension cord
specifically approved for outdoor
applications.
Minimum wire gage for extension cords
for 120 Volt appliances using 0-6 amps
Cord length (ft) 25 50
Wire size (AWG) 18 16
230 V version
Minimum cross sectional area of wires:
: Cord lengths of 6.5 ft (2 m) or more:
1.5 mm², type H07 RN-F
: Connect trimmer´s plug (1)
to extension cord coupling (2).
100 150
16 14
19