IWC Schaffhausen INGENIEUR CHRONOGRAPH SPORT Instrucciones De Manejo página 26

— 2 6 —
T I M E S E T T I N G
Pull out the crown to position 2. This will stop the movement. To
set the time accurately to the second, it is best to stop the move-
ment as the seconds hand passes 60. You can now set the time by
turning the crown and positioning the minute hand exactly above
the minute stroke. To start the seconds hand, push in the crown
to position 0. When setting the time, please be aware of the date
change, which always takes place at 12 midnight. If this change
has already taken place at 12 noon, you must move the hands
forward by 12 hours.
Important: Although the watch is water-resistant in positions 0,
1 and 2, the crown should always be screwed in again for normal
use (position X).
S E T T I N G Y O U R W A T C H C O R R E C T L Y
To set your watch correctly, proceed as follows:
– Release the crown by turning it to the left.
– Wind the movement (approximately 20 revolutions of the crown).
– Pull out the crown to position 1.
I N G E N I E U R C H R O N O G R A P H S P O R T