Delta RT-40 Manual De Instrucciones página 17

HOW TO AdJUST THE FENCE PARALLEL TO THE MITER gAUgE SLOTS
IMPORTANT: Be certain that the miter gauge slots are parallel with the blade before adjusting the fence.
Move the fence (A) Fig. 45 until the bottom edge is aligned with the edge of one of the miter gauge slots and lock it in
place with the lock clamp (B). If the fence is not parallel to the slot, raise the lock clamp, and lift the fence off of the
guide tube. Use a 3/16" hex wrench (not supplied) to tighten or loosen the adjustment screw (either C or D) Fig. 46 that
applies.
IMPORTANT: Any necessary adjustments should be very small.
Fig. 45
HOW TO AdJUST THE CLAMP HANdLE
When the clamp handle is in the "down" position (Fig.
47), the fence will lock to the guide tube. If this is not the
case, lift the clamp handle and raise the fence assembly
off of the guide tube. Slightly tighten the two adjusting
screws (D) and (E) an equal amount, using a 3/16" hex
wrench. Replace the fence assembly and check for cor-
rect clamping. Repeat as necessary.
IMPORTANT: After adjustment of the clamp handle, re-
check to see that the fence and miter gauge slots are
parallel.
HOW TO AdJUST THE MITER gAUgE ANd STOP ROdS
You can adjust the miter gauge (A) Fig. 48 right and left by loosening the locking handle (B), pushing down on lever, and
rotating the miter gauge body. Lock the body in position with the locking handle (B)
You can adjust the stop rods (D) Fig. 49 by loosening the set screw (E) or loosening the knob (F). The stop rods can be
removed by loosening the knob (G).
B
Fig. 48
A
B
A
C
E
Fig. 47
F
d
17
d
Fig. 46
F
Fig. 49
g
E