Safety Instructions; Electrical Safety; Work Area - Hilti DAG700-P Manual De Instrucciones

Obligation signs
Wear eye Wear a hard
en
protection
Wear
breathing
protection
Symbols
Read the Return waste
operating material for
instructions recycling.
before use
Hertz Alternating
current
Revolutions Diameter
per minute

2. Safety instructions

2.1 General Safety Rules
a) Warning! Read and understand all instruc-
tions.Failure to follow all instructions listed below
may result in electric shock, fire and/or serious
personal injury. SAVE THESE INSTRUCTIONS.

2.1.1 Work Area

a) Keep your work area clean and well lit. Cluttered
benches and dark areas invite accidents.
b) Do not operate power tools in explosive atmo-
spheres, such as in the presence of flammable
liquids, gases or dust. Power tools create sparks
which may ignite the dust or fumes.
2
Printed: 07.07.2013 | Doc-Nr: PUB / 5069467 / 000 / 00
Wear ear
hat protection
Volts
Rated speed
Double
insulated
Location of identification data on the power tool
The type designation and serial number can be found
on the type identification plate on the machine or tool.
Make a note of this data in your operating instructions
and always refer to it when making an enquiry to your
Wear
Hilti representative or service department.
protective
gloves
Type:
Generation: 01
Serial no.:
Amps
c) Keep bystanders, children and visitors away
while operating a power tool. Distractions can
cause you to lose control.

2.1.2 Electrical Safety

a) Double-Insulated tools are equipped with a po-
larized plug (one blade is wider than the other).
This plug will fit in a polarized outlet only one
way. If the plug does not fit fully in the outlet,
reverse the plug. If it still does not fit, contact
a qualified electrician to install a polarized out-
let. Do not change the plug in any way. Double
Insulation eliminates the need for the three-wire