Insert Tools, Accessories; Troubleshooting; Disposal - Hilti DAG700-P Manual De Instrucciones

8. Insert tools, accessories

Discs of max. 7" diameter designed for use at 8500 /min and a peripheral speed of 80 m/sec
Abrasive discs
Diamond discs
Wire brushes
Abrasive flap discs
Accessories
Guard with cover plate
Vacuum cleaner from the Hilti range
Inner clamping flange for flat discs
Outer clamping flange for flat discs

9. Troubleshooting

Fault
The power tool doesn't start.
The power tool doesn't
achieve full power.

10. Disposal

Most of the materials from which Hilti power tools or appliances are manufactured can be recycled. The
materials must be correctly separated before they can be recycled. In many countries, Hilti has already made
arrangements for taking back your old power tools or appliances for recycling. Please ask your Hilti customer
service department or Hilti representative for further information.
Printed: 07.07.2013 | Doc-Nr: PUB / 5069467 / 000 / 00
DC-D 7"
Possible cause
Interruption in the electric supply.
The supply cord or plug is defec-
tive.
The carbon brushes are worn.
The extension cord's conductor
cross section is inadequate.
Type 1, type 41, type 42
Max. 7"
Max. 7"
Remedy
Plug in another electric appliance
and check whether it works.
Have the parts checked by a trained
electrical specialist and replaced if
necessary.
Have it checked by a trained electri-
cal specialist and replaced if neces-
sary.
Use an extension cord with an ade-
quate conductor cross section.
en
13