Using Extension Cords - Hilti DAG700-P Manual De Instrucciones

Use only grinding or cutting discs of max. 7" in diameter that are approved for use at a spindle speed of at
least 8500 /min and with a permissible peripheral speed of 80m/sec.
To avoid the risk of injury, use only genuine Hilti accessories and insert tools.
Working on materials hazardous to the health (e.g. asbestos) is not permissible.
Nationally applicable industrial safety regulations must be observed.
en
Modification of the power tool or tampering with its parts is not permissible.
The power tool may be operated only when connected to a power supply providing a voltage and frequency in
compliance with the information given on its type identification plate.
The working environment may be as follows: construction site, workshop, renovation, conversion or new
construction.
The power tool is designed for professional use and may be operated, serviced and maintained only by trained,
authorized personnel. This personnel must be informed of any special hazards that may be encountered. The
power tool and its ancillary equipment may present hazards when used incorrectly by untrained personnel or
when used not as directed.
Take the influences of the surrounding area into account. Do not use the power tool or appliance where there
is a risk of fire or explosion.
3.2 Grips
Side handle
3.3 Switches
Lockable on / off switch
3.4 Items supplied as standard include:
1 Power tool
1 Guard
1 Side handle
1 Clamping flange for offset discs
1 Clamping nut
1 Wrench
1 Operating instructions
1 Cardboard box

3.5 Using extension cords

Use only extension cords of a type approved for the application and with conductors of adequate cross section.
The power tool may otherwise loose performance and the extension cord may overheat. Check the extension
cord for damage at regular intervals. Replace damaged extension cords.
Recommended minimum conductor cross section and max. cord lengths
Conductor cross section
Mains voltage 110-120 V
Do not use extension cords with 16 AWG conductor cross section.
3.6 Using extension cords outdoors
When working outdoors, use only extension cords that are approved and correspondingly marked for this
application.
8
Printed: 07.07.2013 | Doc-Nr: PUB / 5069467 / 000 / 00
14 AWG
75 ft
12 AWG
125 ft