FAR KJ 45/S Instrucciones De Uso página 17

KJ 45/S KJ 45/S
CHANGE OF SIZE (fi g. f10-f11-f12-f13)
The riveting tool is supplied with 6 pairs of threaded tie-rods (A),
heads (B), entreiners (R) and, spacers (S) only for tie-rods from M4
to M8 (f10).
To change the size make as follows:
• Unscrew the cone-carrying head (O) by a 22 mm standard spanner
(f11).
• Extract the threaded tie-rod, pushing and lifting it at the same
time (f12).
• After preparing the threaded tie-rod (A) of the size you need,
arrange and keep the components as shown in f13 and assemble.
Be sure that the components are correctly placed, rotating the
tie-rod by hand (f13).
ATTENTION!
• The side of the component (R) to be entered in the head of the
tie-rod is provided of a magnet to avoid accidental fall during the
operations of change of size.
• Screw the cone carrying heads (O) by a 22 mm standard spanner
and clamp correctly.
ATTENTION!
Disconnect the machine before carrying out the
above-mentioned operations.
M4 ÷ M8
A B R S
O
22 mm
Revision - 00
M10 - M12
A B R
GB
f10
f11
Date 11-2008
f12
f13
17