Tool Identification; Main Components; General Notes And Use; Technical Data - FAR KJ 45/S Instrucciones De Uso

KJ 45/S KJ 45/S

TOOL IDENTIFICATION

The riveting tool KJ 45/S is identifi ed by the label showing the name
and the address of the manufacturer and the model also. If any service
is requested, please make reference to the data shown on the label.
Name and address
of manufacturer

GENERAL NOTES AND USE

The tool can be employed only for threaded inserts M4÷M12.
The KJ 45/S/S hydropneumatic system assures more power
than the pneumatic system used for other models. That means a
reduction in the problems due to the wear and tear of the components,
therefore, there will be an increase in reliability. The technical solutions
adopted reduce the dimensions and the weight of the tool, which is
very handy for these reasons. The possibilities of leakage from the
oil-dynamic system, are eliminated by some sealed gaskets, which
solve this problem.
Revision - 00
GB

MAIN COMPONENTS

A) ..............................................................................Threaded tie rod
B) ................................................................................................Head
C) ..................................................................Ring-nut clamping head
D) ........................................................................Control push-button
E) ............................................................ Compressed air connection
F) .....................................................................Pressure control valve
G) ........................................................................... Protection bottom
H) .............................................................................Pneumatic motor
I) ..................................................................................... Oil tank plug
L) ....................................................................... Balancer connection
M) ....................................................................Stroke-adjusting knob
N) ...............................................................................Stroke indicator
O) ..........................................................................Tube carrying head
P) ................................................................... Forced unscrewing rod
Q) ............................................................................
with M10 tie rod
*
Model

TECHNICAL DATA

• Working pressure ............................................................ 6 - 7 BAR
• Min. int. diam. of the compressed air
feeding hose ........................................................... ø min. = 8 mm
• Max free air consumption per cycle ....................................
• Force (6 BAR) ........................................................................
• Noise level ..................................................................... < 75 db(A)
• Weight (with equipment for M10) ..........................................2.9 Kg
• Working temperature ........................................................ -5°/+50°
• Root mean square in total acceleration
frequency (Ac) to which
the arms are subjected ..............................................< 2.5 m/sec2
** nl = litres at 20°, pressure of 1 atmosphere
Date 11-2008
Air-entry valve
10 nl**
28 kN
13