Ir Programming Port; Parameter Setting Through Pc; Parameter Setting (Setup) From Front Panel - LOVATO ELECTRIC DCRG8 Manual Operativo

10

IR PROGRAMMING PORT

– The parameters of the DCRG8 can be configured through the front optical port, using the IR-USB programming dongle, type CX01, or with the IR-WiFi
dongle, type CX02.
– This programming port has the following advantages:
• You can configure and service the DCRG8 without having to access the device at the rear or to open the electrical panel.
• It is galvanically isolated from the internal circuits of the DCRG8, guaranteeing the greatest safety for the operator.
• High speed data transfer.
• IP54 front panel protection degree.
• Limits the possibility of unauthorised access with device configation.
– Simply hold the CX... dongle in front of the panel and insert the pins on the relevant connectors; the devices will recognise each other as shown by the green
colour of the LINK LED on the programming dongle.
PARAMETER SETTING (SETUP) WITH PC
– You can use the DCRJ remote control software to transfer setup parameters (previously programmed) from the DCRG8 to the PC hard drive and vice versa.
– The parameters can be partially transferred from the PC to the DCRG8, by transferring only the parameters of specific menus.
– In addition to the parameter setup, the PC can be used as follows:
• Logo customising, displayed at power-up and every time you exit keyboard setup.
• Creating an information page where you can enter application information, characteristics, data, etc.

PARAMETER SETTING (SETUP) FROM FRONT PANEL

– To open the parameters programming menu (setup):
• Put the device in MAN mode and disconnect all the steps.
• With measurements page viewed, press
• Select icon . If it is disabled (displayed in grey), you must enter the password (See chapter Password access).
• Press again to open the setup menu.
– The table shown below is displayed, with the setting submenus for all the parameters on the basis of their function.
– Select the required menu with key ▲ or ▼ and confirm with
– Press ◄ to return to the values view.
– The following table lists the available submenus:
Code MENU
M01 UTILITY
M02 GENERAL
M03 STEPS
M04 MASTER OUTPUTS
M05 MASTER / SLAVE
M06 SLAVE1 OUTPUTS
... ...
M13 SLAVE8 OUTPUTS
M14 PROG. INPUTS
M15 PASSWORD
M16 COMMUNICATION
M17 BASE PROTECTIONS
M18 HARMONIC PROT.
M19 MISCELLANEOUS
M20 LIMIT THRESHOLDS
M21 COUNTERS
M22 ANALOG INPUTS
M23 ANALOG OUTPUTS
M24 ENERGY PULSES
M25 USER ALARMS
M26 ALARM PROPERTIES
USB programming dongle type CX01
to call up the main menu.
.
Setting: Menu selection
DESCRIPTION
Language, brightness, display pages, etc.
Panel/system data
Capacitor step configuration
Programmable outputs of master device
Device role (master or slave)
Programmable outputs of slave device 01
Programmable outputs of slave device 08
Programmable digital inputs
Password access management
Communication channels parameters
Basic protections of the panel
Harmonic protection (EXP1016 module)
Various settings
Limit thresholds on measurements
General programmable counters
Programmable analog inputs
Programmable analog outputs
Pulses for energy meters increment
Programmable user alarms
Actions caused by alarms
G
B