Astralpool Heliox UV MP Serie Manual De Instalación Y Mantenimiento página 4

3. SAFETY WARNINGS AND RECOMMENDATIONS: ______________________________________________________________
Do not use this system to a different application for which it was designed.
The equipment should be assembled and handled by truly qualified people.
Current electrical and accident prevention regulations should be followed.
Under no circumstances will the manufacturer be held responsible for the
assembly, installation or start-up, nor any handling or fitting of components
unless they are carried out on its premises.
HELIOX UV MP treatment systems (codes 52200 to 52203) operate at 230
VAC / 50-60Hz, or 380 VAC / 50-60 Hz (codes 52204-52206). Do not attempt
to alter the system to operate at a different voltage.
Check all the electrical connectors are well tightened to avoid false contacts
and their consequent overheating.
Install the control panel so that the cooling grids are not obstructed.
HELIOX UV MP treatment systems (codes 52200 to 52206) have an IP54
protection degree that not allows outdoor installation. They should never be
installed in places susceptible to flooding.
Prior to the installation or replacement of any system component make sure it
has been previously disconnected from the mains, and there is no water flow
through it. Use only spare parts supplied by AstralPool.
Never remove the lock nut of the quartz sleeve when the water is recirculating
through the UV reactor as it could be expelled and causing damage.
The UV light generated by this equipment can cause serious damage if the
eyes or skin are exposed directly to the lamp. Never connect the system
when the lamp is out of the reactor.
Do not handle the UV lamp until completely cold.
Always handle the UV lamp with gloves, as fat and other impurities deposited
on the surface may reduce its performance and durability. In case you have to
clean the lamp surface use a soft cloth soaked with alcohol.
Keep this Operation Manual.
3