Maintenance; Changing The Dust Filter Bag; Cleaning The Motor Protection Filter - Dirt Devil CARGO Manual De Instrucciones

Aspiradora rodante con bolsa
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 28

5 Maintenance

5.1 Changing the dust filter bag

5
Maintenance
ATTENTION:
Switch off the appliance before changing the dust filter bag. This will pre-
vent dust from damaging the appliance.
NOTE:
You can dispose of the entire contents of the dust filter bag with your
normal domestic waste as long as it contains no substances not allowed
in domestic waste.
A
9
A
4
3
1
2
10

5.2 Cleaning the motor protection filter

11
A
24 h
12
14
A
B B
Change the dust filter bag when the filter bag change indicator in the
window (Fig. 1/4) appears and before prolonged storage or shipping.
For hygienic reasons, change the dust filter bag at least once every
three months.
1. Switch off the appliance and pull the plug from the mains socket,
Chapter 4.3, 'Switching off'.
2. Release the dust compartment cover by pressing the release button
(Fig. 1/5) and then open it until you can feel it snap into place and it re-
mains there.
B
3. Pull forward the retaining clip thus unlocking the dust filter bag (Fig. 9/
A).
NOTE:
If the dust filter bag has a dust lock, close it before removing the bag.
4. Pull the dust filter bag carefully out of the appliance (Fig. 9/B).
5. Take this opportunity to check the motor protection filter as well. Clean
it if necessary,
Chapter 5.2, 'Cleaning the motor protection filter'.
6. Carefully place the dust container inside again (Fig. 10). When doing so
pay attention to the 4 fixed points (Fig. 10/A) that ensure that the dust
filter bag is correctly in place:
- First guide the cardboard shield of the dust filter bag between the two
guide rails (Fig. 10/A1).
- Push the cardboard shield until the end so that it rests on the 3 hold-
B
ers (Fig. 10/A2).
- Ensure that the opening of the cardboard shield completely sur-
rounds the suction tube nozzle (Fig. 10/A3).
- Push the cardboard shield forwards until the retaining clip (Fig. 10/
A4) above the cardboard shield engages.
- The dust filter bag is now secured to the appliance (Fig. 10/B).
NOTE:
The dust compartment cover can only be closed if the dust filter bag has
been installed correctly, i. e. it is on all 4 fixed points (Fig. 10/A) as
described above.
7. Close the dust compartment cover. It clicks shut audibly.
Clean the motor protection filter every time you change the dust filter
B
bag,
Chapter 5.1, 'Changing the dust filter bag'.
Clean the motor protection filter as soon as you see it is dirty.
Replace the motor protection filter as soon as it deforms or is damaged
( Chapter 5.4, 'Spare parts and accessories'). In addition, replace the mo-
tor protection filter every time you open a new dust filter set as it will contain
a new motor protection filter.
1. Switch off the appliance and remove the dust filter bag,
'Changing the dust filter bag', steps 1–4.
2. Pull the dust filter bag up and out (Fig. 11/A).
3. Take this opportunity to check the exhaust filter as well.
If required, clean it together with the motor protection filter.
4. Rinse the motor protection filter thoroughly by hand in clear running
cold or hand warm water until all dirt has been removed (Fig. 11/B).
ATTENTION:
The filters are washable, but not suitable for cleaning in washing
machines or dishwashers. Do not use cleaning agents for cleaning.
Leave the filters to dry after cleaning them with water (approx. 24 hours
at room temperature, Fig. 12/A). Only put them back into the appliance
when they are completely dry.
5. Slide the new/clean and completely dry motor protection filter back be-
hind its 4 guide rails and push it down to the end (Fig. 12/B).
6. Place the dust filter bag inside again
filter bag', step 6.
7. Close the dust compartment cover. It clicks shut audibly.
Chapter 5.1,
Chapter 5.1, 'Changing the dust

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

M7066

Tabla de contenido