Operating Instructions; Preparing The Nebulizer For Use; Connecting Ac Adapter - Omron COMP A-I-R NE-C801KD Manual De Instrucciones

NE-C801S-KDE(V)_main.book Page 11 Friday, December 14, 2018 10:32 AM

Operating instructions

2. Preparing the nebulizer for use

Warning:
Clean and disinfect the nebulizer kit, mask or mouthpiece before using them when as follows:
- the first time after purchase.
- if the device has not been used for a long period of time
- if more than one person uses the same device
For the instructions, refer to "Cleaning and disinfecting" section.
For directions on cleaning and disinfecting refer to Section 4 (page 16-18).
Note: Make sure that the air filter is changed regularly. Refer to Section 7 "Changing the air filter"
(page 20).
2.1

Connecting AC adapter

1.
Make sure that the power switch is turned off.
Check that the power switch is in the off (
2.
Inserting the power plug of the AC
adapter into the power connector
on the compressor.
3.
Plug the AC adapter into a power
outlet.
Notes:
• When disconnecting the AC
adapter, unplug the AC adapter
from the power outlet before
removing the power connector on
the compressor.
• Do not place the device in a location
where it is difficult to disconnect the
power cord.
) position.
Power Plug
Power Connector
Power Outlet
EN
11