Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Safety
IMPORTANT SAFETY INSTRUCTIONS
SAVE THESE INSTRUCTIONS - This manual contains
important instructions that should be followed during
installation, operation, and maintenance of the product.
This is the safety alert symbol. When you see this
symbol on your pump or in this manual, look for one of
the following signal words and be alert to the potential
for personal injury!
indicates a hazard which, if not avoided,
will result in death or serious injury.
indicates a hazard which, if not avoided,
could result in death or serious injury.
indicates a hazard which, if not avoided,
could result in minor or moderate injury.
NOTICE addresses practices not related to
personal injury.
Carefully read and follow all safety instructions in this
manual and on pump.
Keep safety labels in good condition. Replace missing or
damaged safety labels.
California Proposition 65 Warning
This product and related accessories contain
chemicals known to the State of California to cause
cancer, birth defects or other reproductive harm.
GENERAL SAFETY
1. To avoid risk of serious bodily injury and property
damage, read the safety instructions carefully before
installing this pump.
2. Follow local and/or national plumbing and electrical
codes when installing the pump.
3.
Risk of explosion. Hazardous Pressure.
The pump body may explode if used as a booster
pump unless a relief valve capable of passing the full
pump flow at 75 PSI (517 kPa) is installed.
4. Never run the pump dry. To do so can damage inter-
nal parts, overheat pump (which can cause burns to
people handling or servicing pump), and will void
warranty.
5.
Risk of fire and explosion. Can cause
severe injury, property damage or death. To avoid risk
of fire and explosion, Pump Water Only with this
pump. Do not use this pump in an atmosphere that
might contain flammable fumes or vapors.
For parts or assistance, call Flotec Customer Service at
6.
Risk of explosion and scalding. If water is
trapped in the pump during operation it may turn to
steam. Trapped steam can lead to an explosion and
burns. Never run the pump with the outlet closed or
obstructed.
7.
Risk of burns. Do not touch an operat-
ing motor. Modern motors cano operate at high tem-
peratures. To avoid burns when servicing the pump,
allow it to cool for 20 minutes after shut-down before
handling.
ELECTRICAL SAFETY
Risk of electric shock. Can shock, burn or
kill. The pump is supplied with a 3-conductor grounding
type cord. Connect only to a properly grounded, GFCI
protected outlet. Do not lift pump by the electrical cord.
• Ground pump before connecting to power supply.
Disconnect power before working on pump, motor
or tank.
• The pump is non-submersible. Keep the motor dry at
all times. Do not wash the motor. Do not immerse.
Protect the motor from wet weather.
• If using an extension cord, use only a UL approved
indoor/outdoor, 3-wire, grounding type cord. Do not
allow any part of the cord or the receptacle ends to
sit in water or in damp locations.
• Unplug the pump before servicing. To avoid fatal
shocks, proceed as follows if the pump needs
servicing.
• Disconnect the power to the pump outlet box before
pulling the pump plug. After the plug is pulled, let
the pump cool for 20 minutes before attempting to
work on it.
• Take extreme care when changing fuses. To reduce
the chance of fatal electrical shock, DO NOT stand
in water or put your finger in the fuse socket.
• Ground electrical outlet box.
• Plug pump into a Ground Fault Circuit Interrupter
(GFCI) protected grounded outlet only.
800-365-6832
2
Publicidad
Tabla de contenido
