Cleaning Of The Spray Gun - SATA SATAjet 3000 B Instrucciones De Servicio

Operating Instructions SATAjet 3000 B RP/HVLP (DIGITAL)
EN EN
7.2. Adjust material flow
rial flow control fully opened
With the material flow control fully opened, the wear of the fluid tip and
paint needle is reduced to a minimum. Please select the correct nozzle
size depending on the material to be applied and the required applica-
tion speed.
7.3. Adjust spray fan pattern
• Adjust flat fan (factory setting) [5-1].
• Adjust round fan [5-2].
7.4. Painting
For painting, the trigger has to be fully pulled [6-1]. Operate the spray
gun according to [6-2]. Maintain spray distance according to chapter 2.
8.

Cleaning of the Spray Gun

• Prior to cleaning, please disconnect the paint spray gun from the
compressed air circuit!
• Risk of injury due to unexpected leakage of compressed air or mate-
rial!
• Empty paint spray gun and gravity flow cup completely, dispose of
paint material appropriately!
• Disassemble and install components very carefully! Exclusively use
included special tools!
• Use neutral cleaning solution (pH value 6 to 8)!*
• Do not use acids, lyes, pickling agents, unsuitable re-
claimed materials or other aggresive cleaning media, such
as Toluol, for example!*
• Do not soak paint spray gun in cleaning solution!*
• Do not clean cover plate of the electronic pressure display with
pointed, sharp or rough objects!
122 122
[4-1], [4-2], [4-3] und [4-4] - mate-
Note!
Warning! Attention!