Rothenberger ROGROOVER 1 - 12 Instrucciones De Uso página 25

 Tighten the screws (8) again.
Model of Model of
pinch roller Knurl wheel
Small Pinch Small Knurl
Roller Shaft
33/48 33/48
Medium-Sized Medium
Pinch roller Knurl Shaft
60/168 60/168
Large Pinch Large Knurl
Roller Wheel
219/325 219/325
 Select a roller and a drive shaft of the same
size.
 Lower the upper roller until it almost touches
the drive shaft at the point where its diameter is
at its greatest.
 Loosen the two screws (8) of the head. It is not
necessary to remove them.
 Using the screw (5), turning this in both direc-
tions, we move the head forwards or backwards
depending on the direction of rotation. Adjust
this until it is perfectly aligned.
Nominal Actual
Pipe Dia. Pipe
(inch) Dia.
+/– 0,5
(inch)
(mm)
1" 33.7 15.88
1-1/4" 42.4 15.88
1-1/2" 48 15.88
2" 60 15.88
2-1/2" 76 15.88
3" 89 15.88
4" 108 15.88
4" 114 15.88
5" 133 15.88
5" 140 15.88
6" 159 15.88
6" 165 15.88
6" 168 15.88
8" 219 19.05
10" 273 19.05
12" 325 19.05
ENGLISH
A B C
+/– 0,5 +/– 0,5
(mm) (mm)
7.14 1.65
7.14 1.65
7.14 1.65
8.74 1.65
8.74 1.98
8.74 1.98
8.74 2.11
8.74 2.11
8.74 2.11
8.74 2.11
8.74 2.16
8.74 2.16
8.74 2.16
11.91 2.34
11.91 2.39
11.91 2.77
Diameter of
Groove Bottom
Max. Min.
(mm) (mm)
30.23 29.85
38.99 38.61
45.09 44.70
57.15 56.77
72.26 71.80
84.94 84.48
103.73 103.22
110.08 109.57
129.13 128.62
135.48 134.97
153.48 152.45
160.78 160.22
163.96 163.40
214.40 213.76
268.28 267.59
318.29 317.53
23