Makita DGA405 Manual De Instrucciones página 7

Indicating the remaining battery
capacity
(Only for battery cartridges with "B" at the end of the
model number.)
► 1. Indicator lamps 2. Check button
Press the check button on the battery cartridge to indi-
cate the remaining battery capacity. The indicator lamps
light up for few seconds.
Indicator lamps
Lighted Off
NOTE:
• Depending on the conditions of use and the
ambient temperature, the indication may differ
slightly from the actual capacity.
Switch action
CAUTION:
• Before installing the battery cartridge into the
tool, always check to see that the switch lever
actuates properly and returns to the "OFF"
position when released.
• Do not pull the switch lever hard without pull-
ing the lock-off lever. This can cause switch
breakage.
1
2
Remaining
capacity
Blinking
75% to 100%
50% to 75%
25% to 50%
0% to 25%
Charge the
battery.
The battery
may have
malfunctioned.
1
► 1. Lock-off lever 2. Switch lever
To prevent the switch lever from being accidentally
pulled, a lock-off lever is provided. To start the tool, pull
the lock-off lever toward the operator and then pull the
switch lever. Release the switch lever to stop.
Accidental re-start preventive
function
Even if installing the battery cartridge while pulling the
switch lever, the tool does not start.
To start the tool, first release the switch lever. Then pull
the lock-off lever and then pull the switch lever.
Indicating remaining battery
capacity
(Country specific)
1
► 1. Battery indicator
When you turn the tool on, the battery indicator shows
the remaining battery capacity.
The remaining battery capacity is shown as the follow-
ing table.
7 ENGLISH
2