Roadstar TRA-2425PSW Manual De Instrucciones página 5

•
Press SET button (3) again to select the day
•
Turn the Tune + / - knob to set the correct day
•
Press SET button (3) to confirm the calendar setting
ALARM SETTING
Make sure the POWER switch is set to the 'Off' position. The time or alarm time cannot be
set or adjusted while the unit is 'On'.
•
Press the Alarm button (13) and select the Alarm 1 or Alarm 2
•
Press the SET button (3) and the display will show the minute 00 will flash and press Tune
+/- to select the minute.
•
Press the SET button (3) again to confirm setting, then the Display will show 00:00 and the
first 00 will flash, then press Tune +/- to select the correct hours.
•
Press SET button (3) to confirm the alarm setting
•
Press ALARM button (13) to enter in normal clock mode
ALARM OFF
During Alarm on, press SET button (3) or ON/OFF button (11). The alarm sound goes off but
the Alarm setting remains.
ALARM VOLUME SETTING
•
In Radio Alarm, the Alarm Volume is set with the last volume level used during playback.
• In Buzzer Alarm, the Alarm level is fixed.
WAKE TO BUZZER ALARM
•
Alarm 1 and Alarm 2 both have "wake to buzzer Alarm" function
•
Set the Alarm time as shown above
•
Turn the Tuning knob to set Alarm to wake up to Buzzer alarm
WAKE TO MUSIC
•
Repeat the steps of Alarm Time Setting, Alarm 1 and Alarm 2 both have the "wake to music"
function.
•
Press the Alarm button (13) once to set the desired Alarm 1 time
•
Press the Alarm button (13) twice to set the desired Alarm 2 time
•
Turn the Tune +/- knob once after alarm setting to activate wake to Radio function
•
After finish the Alaem 1 or Alarm 2 time setting, press the SET button (3) once to confirm
alarm timer setting
5
English
SNOOZE / SLEEP
SLEEP FUNCTION
•
•
SNOOZE
The alarm can be temporarily turned off manually by pressing the SNOOZE button; the alarm
will turn back on 5 minutes later automatically.
This feature can be repeated endlessly.
HEADPHONES
Headphones should have a 3.5mm diameter stereo plug and an impedance of 8-32 ohms. When
headphones are connected (8), the speaker is automatically disconnected.
SPECIFICATIONS
Power Supply
AC:
DC:
Radio Frequency Coverage
FM:
MW:
SW:
Speaker
Ouput power:
General
Headphone:
Impedance
Specifications and the design are subject to possible modifications without notice due to improvement.
6
English
•
The Radio Memory icon appear in the display. During that time, turn the Tuning +/- knob to
select the desired Radio station stored in tehe memory before
•
Press the Set button (3) to confirm
•
Press the ON/OFF button (11) to turn ON the unit, then adjust the Volume to the desired
level. Press the ON/OFF button (11) to switch OFF the Radio, then it switch ON automatically
at the preset Alarm time
Press ON button (11) to switch ON the radio. Press the Snooze / Sleep Button (7) sequentiually
to display will show 90, press again is 80/70/60/50.....10, then press again is off.
After set the Sleep function and when finish, then the unit will off automatically.
230V ~ 50Hz
4 x UM3 Battery
88 - 108 MHz
540 - 1600 kHz
3,16 - 18.10 MHz in 10 bands
4 Ohms, 3-5 W
0.8 W RMS, 10% THD
3.5mm jack plug, 8-32W
32 Ohms