Power Supply; Radio Operation - Roadstar TRA-2425PSW Manual De Instrucciones

MAINS (AC) OPERATION
This unit is designed to operate on AC 230V 50Hz current only. Connecting it to other power
sources may damage the unit.
Caution
To prevent electric shock disconnect from the mains before removing cover. No user serviceable
parts inside. Refer servicing to qualified service personnel.
Safety Precaution
Do not allow this unit to be exposed to rain or moisture.
Mains Supply: AC230Volts / 50Hz - AC only
This symbol means that this unit is double insulated. An earth connection is not required.

POWER SUPPLY

• Remove the Radio carefully from the box, retaining the packaging for future use.
• Please read this instruction book carefully before operating this unit.
AC Power Operation
• Connect the AC Power Cord to your AC household mains outlet and switch on the mains
supply. Make sure the voltage is compatible.
Battery Operation
• Remove mains lead from the unit for battery operation.
• Open the Battery Compartment at the back of the radio and insert four UM3 batteries
following the polarity diagram shown inside the battery compartment.
• Batteries should be removed form the compartment if the unit is not to be used for some
time.
• Flat batteries should be removed from the unit to avoid leakage

RADIO OPERATION

Antenna
For FM reception there is a built-in telescopic FM antenna (19) at the rear of the unit. Extend the
antenna and move it around to obtain the best reception.
For MW / SW reception the signals are picked up through a built-in ferrite antenna. Your may
have to orient the unit to obtain the best reception.
English
3
•
•
•
•
Store Radio Stations manually
This unit can store 24 stations (8 FM, 8 MW and 8 SW).
•
•
•
•
•
Store Radio Stations automatically
Keep pressed the SET button (3) 3 seconds and the Radio will be stored in the memory
sequencially.
CLOCK AND ALARM OPERATION
SETTING THE CLOCK
Make sure the POWER switch is set to the 'Off' position. The time or alarm time cannot be set
or adjusted while the unit is 'On'.
•
•
•
•
CALENDAR SETTING
When the display show the time, press the MODE button (17) once, it show calendar mode.
•
•
•
•
English
4
Press the Power ON/OFF Button (11) to power ON the unit.
Choose the radio wave band (MW, FM or SW) using the BAND Button (5 or 6)
Search for the station of your choice using the Tuning knob (18).
To switch off the radio, press the Power button (11) to OFF.
Tune the desired station as explained above
Press the SET button (3) to enter in preset mode
The icon "CH" flash and appear in the display
Press the M+ or M - buttons to choose the preset number, from 1 to 8.
Press the SET button (3) to confirm the memory setting.
Press the SET button (3) and the display will show the minute 00 will flash and press Tune
+/- to select the minute.
Press the SET button (3) again to confirm setting, then the Display will show 00:00 and the
first 00 will flash, then press Tune +/- to select the correct hours.
Press the SET button (3) again to confirm setting, then the Display will show 24H will flash,
then press Tune +/- to select the 12H or 24H.
Press the SET button (3) to confirm the clock setting,
Press SET button once (3) to select the year
Turn the Tune + / - knob to set the correct year
Press SET button (3) again to select the month
Turn the Tune + / - knob to set the correct month