ECOVACS ROBOTICS DEEBOT OZMO 610 Manual De Instrucciones página 29

No. Malfunction
DEEBOT will not
5 clean automatically at
scheduled time.
DEEBOT misses
6
cleaning area.
Remote Control failure
(effective control range
7
of Remote Control is
5m (16').
The water is not
coming out of the
8
Reservoir when
DEEBOT is mopping.
Possible Causes
Intelligent Scheduling or
Time Scheduling function is
cancelled.
DEEBOT is powered OFF.
The robot's battery is low.
The robot's Suction Intake
is blocked and/or its
components are tangled with
debris.
The cleaning area needs
tidying up.
The batteries in the Remote
Control need to be replaced.
DEEBOT is powered OFF or
the robot's battery is low.
The infrared signal cannot
be transmitted because the
Infrared Emitter on Remote
Control or the Infrared
Receiver on DEEBOT is
dirty.
There is other equipment
interfering with the infrared
signal to DEEBOT.
The Magnet on the Cleaning
Cloth Plate comes off.
The Reservoir runs out of
water.
The water outlets on the
bottom of DEEBOT are
clogged.
5. Troubleshooting
Solutions
Please refer to section 3.4 for details.
Power ON DEEBOT.
Keep DEEBOT powered ON and on
the Docking Station to make sure it
has full battery to work at any time.
Turn the robot's power OFF, clean the
Dust Bin and invert the robot. Clean
the robot's Suction Intake and Side
Brushes.
Please remove small objects from the
floor, and tidy up the cleaning area
before DEEBOT starts cleaning.
Replace with new batteries making
sure they are installed correctly.
Make sure DEEBOT is powered ON
and fully charged.
Use clean dry cloth to wipe the Infrared
Emitter on Remote Control and the
Infrared Receiver on DEEBOT.
Avoid using the Remote Control near
other equipment using infrared signals.
Please contact Customer Service.
Add water into the Reservoir.
Check the water outlets on the bottom
and clean.
27
FR-CA EN