Connecting The Inverter To The Exhaust System; Connecting The Inverter - Dometic Waeco SinePower MSP 1012 Instrucciones De Uso

_MSP702_MSP2524.book Seite 45 Dienstag, 22. September 2009 4:55 16
SinePower
9 Connecting the inverter to the exhaust
system
You can connect the inverter to an exhaust system. Thereby the warm ex-
haust is driven out of the internal chamber.
➤ Set the exhaust adapter (fig. 7 2, page 6) on the front side of the
inverter (fig. 7 1, page 6) over the fan, so that the screws fit into the
screw holes.
➤ Attach the exhaust adapter using the supplied screws.
➤ Connect the hose support (not included, fig. 7 3, page 6) to the exhaust
adapter.
➤ Attach the exhaust system hose (fig. 7 4, page 6) to the hose support.
Note
I
SinePower MSP 2012, MSP 2024, MSP 2512 and MSP 2524 are
equipped with two fans. With these devices, mount an exhaust
adapter in front of each fan and attach an exhaust hose.
10

Connecting the inverter

Caution – danger of electrocution!
e
Incorrectly connecting the inverter can be fatal for the user. The de-
vice can only be connected by a trained professional who is familiar
with the relevant VDE (German Engineering Society) regulations.
This chapter is solely intended for trained professionals who are familiar with
the relevant VDE (German Engineering Society) regulations!
10.1 Notes on connecting
Warning!
e
Never use the inverter on vehicles where the positive terminal of
the battery is connected to the chassis.

Connecting the inverter to the exhaust system

45