Installation Procedure - Toto TL970dD Manual De Instalación Y Del Propietario

insTaLLaTion procedure

1. spout installation
 make sure water supply is turned
off�
 After applying the top finish,
remove the plug from the spout
shank�
 loosen setscrew on the back of the
spout�
 remove the spout adapter�
 Thread the spout adapter onto the
spout shank�
 Take care not to damage the o-ring�
 Carefully insert the spout onto the
spout adapter� Take care not to
damage the o-rings�
 secure the spout with setscrew�
2. valve body installation
insert the valve body from underside

of the sink� make sure the Cold
side is on the right and the hot side
is on the left�
place rubber gasket underneath the

deck adapter onto the valve body
until it bottoms out� make sure
rubber washer lays flat in the groove
of the deck adapter�
position the valve body as shown

below then tighten the locknut�
screw in handle-adapter and push in

stem adapter from the top�
repeat procedure for the other

installation
T-Connecctor
spout
gasket
washer
nut
rubber gasket
rubber
washer
Valve body position
(Bottom View)
4
lift rod
gasket
gasket
lock nut
o-ring
T-Connecctor
o-ring
stem adapter
handle adapter
deck adapter
rubber
Connector
washer
Brass
washer
Valve Body
lock nut