Installation Procedure - Toto TBMV Manual De Instrucciones Y Del Propietario

ssembly (2)

INSTALLATION PROCEDURE

Gasket
1. Thread mounting nut to the bottom of
(Rubber)
the mounting pipe body. Place washer
and gasket as shown.
Washer
(Metal)
Mounting
Nut
Collar
2. Pass the mounting pipe body up through
the installation hole.
Insert the gasket and fasten the collar to
the pipe body until it stops.
Gasket
3. Fixate the mounting pipe by threading
the mounting nut up the pipe until hand
tight. Tighten the retaining screws
equally to secure.
Do not overtighten!
4. Fasten the leader hose to the bottom
opening of the diverter.
Pass the hose up through the handshower
mount. Leave end of hose above deck for
future handshower installation.
Secure hose above deck
with a loop of tape.
5. Leave diverter plug in place while conducting
leak testing.
Construction of access panel in tub surround for
future service is recommended.
Diverter Assembly*
Diverter Assembly*
- Handshower Mount (TBMV
Gasket
(Rubber)
Washer
(Metal)
Mounting
Nut
Handshower Outlet
Collar
Gasket
6
Handshower Outlet
(TBMT Only)
(TBMT Only)
Collar
Gasket
Mounting
ONLY)
Gasket
(Rubber)
Washer
(Metal)
Mounting
Nut
Nut