Installation Procedure - Toto TS170T Manual De Instrucciones

Plumbing Setup
1. Connect valves with 1/2" pipe.
2. Drain water supply pipes
completely.
3. Connect hot and cold water
supply lines.
4. Finish the wall.
CAUTION: Do not begin trim
installation before you have checked the
waterflow and filters.
1. Install the stem adjuster into the valve.
2. Confirm that the distance between
finished wall and top of limiter collar
is between 1" (25mm) and 1-3/8"
(35mm).
If necessary, remove the spacer
to correct the distance (see next
page).

InSTallaTIon PRoCeDURe

Showerhead
Dual vol.
control valve
Thermostatic
mixing valve
Each item is
sold separately.
Wall spout
Stem adjuster
Limiter Collar
5
1/2" pipe
Single vol.
control valve
HOT
COLD
Handshower
adapter
Thermostatic
mixing valve
1" (25 mm) MIN
1-3/8" (35 mm) MAX