Fitting Instructions; Warranty - Altrad Belle PCX 20A Manual Del Operador

Tabla de contenido

1. Unscrew the 2 x M10 Bolts to a height of 15mm, then lift the M10 Flat and Spring Washer to the head of the Bolts (See Image 1)

2. Line the slots in the Wheel Kit with the M10 Bolts.

3. Slide the Wheel Kit into place. Take care to push it on until the Bolts make contact with the bottom of the slot and cannot be pushed

on any further.

4. Release the M10 Flat and Spring Washers so that they sit on top of the Wheel Kit. They should now be visible to the operator.

5. Re-tighten the M10 Bolts to a Torque Setting of 55Nm.

Your new Belle Group 'PCX 20A' single direction plate compactor is warranted to the original purchaser for a period of one-year (12

months) from the original date of purchase. The Belle Group warranty is against defects in design, materials and workmanship.

The following are not covered under the Belle Group warranty:

1. Damage caused by abuse, misuse, dropping or other similar damage caused by or as a result of failure to follow assembly,

operation or user maintenance instructions.

2. Alterations, additions or repairs carried out by persons other than Belle Group or their recognised agents.

3. Transportation or shipment costs to and from Belle Group or their recognised agents, for repair or assessment against a

warranty claim, on any machine.

4. Materials and/or labour costs to renew, repair or replace components due to fair wear and tear.

The following components are not covered by warranty.

· Drivebelt/s

· Engine air ¿ lter

· Engine spark plug

Belle Group and/or their recognised agents, directors, employees or insurers will not be held liable for consequential or other

damages, losses or expenses in connection with or by reason of or the inability to use the machine for any purpose.

Warranty Claims

All warranty claims should ¿ rstly be directed to Belle Group, either by telephone, by Fax, by Email, or in writing.

For warranty claims:

Tel: +44 (0)1298 84606

Write to:

Belle Group Warranty Department,

Sheen, Nr. Buxton,

Derbyshire

SK17 0EU

England.