Removing Your Old Toilet; T-Bolt Installation - Jacuzzi Perfecta Instrucciones De Instalación Y De Funcionamiento

Universal 2-Piece Toilet Series

Removing Your Old Toilet

X
X
Turn off the water supply and then flush the toilet to
empty the tank. Use a sponge and bucket to pick up any
water left in the bowl or tank.
X
Y
Disconnect the water supply line from the toilet tank.
X
Z
Disassemble the tank from the bowl by removing the lock
nuts from the underside of the tank.
X
[
Pry off bolt caps and then remove the nuts that secure
the toilet to the floor. Use a rocking motion to remove the
old toilet.
X
\
Scrape the old wax gasket from the floor flange
(Figure 1).
When complete, proceed to the "T-Bolt Installation" section.

T-Bolt Installation

All toilets (Perfecta™, Maxima™, Era™ and
Espree™) use the same installation kit. The
following installation instructions will pertain to all
four toilets.
If the floor flange (commercially available) is
corroded from exposure to water, replace before
proceeding. Please refer to the installation
instructions that come packaged with the floor
flange.
If this is a new bathroom, install a ⅜" I.P.S. water
supply and shut-off valve.
X
X
Before installing a new wax gasket, install flange
T-bolts and bowl nuts onto toilet flange
(Figure 2).
X
Y
Place the flat head of the T-bolt into the opening on
the floor flange.
X
Z
Slide the T-bolt along the floor flange channel until
it stops at the end of the channel and is sitting
vertically (straight up and down).
X
[
Thread on the plastic bowl spacer until it is resting
on the floor flange.
When complete, proceed to the "Wax Ring Installation"
section.
Installation and Operation
www.jacuzzi.com
Figure 1
Plastic Bowl
Spacer
T - Bolt
Floor Flange
Floor Flane Channel
Figure 2
Page 5