Securing The Toilet; Tank-To-Bowl Assembly - Jacuzzi Perfecta Instrucciones De Instalación Y De Funcionamiento

Universal 2-Piece Toilet Series

Securing the Toilet

X
X
Place the following parts onto the T-bolt in the order
listed (Figure 6):
•
Bevel disc
•
Flat washer
•
Bowl nut
•
Cap (if applicable).
X
Y
Once the bowl nut has been threaded onto the
T-bolt, use a 10mm wrench to tighten the bowl nut
(Figure 7).
When complete, proceed to the "Tank-to-Bowl Assembly"
section.
For Espree™ Models Only
X
X
Apply four (4) beads of silicone along the inside edge
of the access panel.
X
Y
Place the access panel over the opening, firmly
pressing into place.
X
Z
When complete, wipe away any excess silicone and
place masking tape over the access panel and let sit
for 24-hours.

Tank-to-Bowl Assembly

X
X
Turn the tank upside down and press the tank-to-bowl
gasket into place over the lower tank opening
(Figure 9).
X
Y
Turn the tank back over (right side up).
Before proceeding further, attach the flexible water
supply line to the fill valve. The water supply line will
be connected once the installation is nearly complete.
Installation and Operation
Silicone
Access Panel
www.jacuzzi.com
Figure 6
Figure 7
Inside Edge
Figure 8
Figure 9
Cap*
Bowl Nut
Flat Washer
Bevel Disk
T - Bolt
(* Not included with
Espree™ models)
10mm Wrench
Access Opening
Tank-to-Bowl
Gasket
Fill Valve
Lower Tank
Opening
Page 7