Leveling The Toilet; Toilet Seat Installation - Jacuzzi Perfecta Instrucciones De Instalación Y De Funcionamiento

Universal 2-Piece Toilet Series

Leveling the Toilet

The toilet must be level once it is installed. If the unit
'wobbles' or has any movement whatsoever, shims
(commercially available) must be used to level the toilet.
X
X
Loosen the bowl nut.
X
Y
Determine which side of the toilet has more movement.
X
Z
Slide a shim between the toilet and the floor. Use a
hammer to gently force into place (Figure 13).
X
[
Level the toilet again. If the toilet is level, retighten the
bowl nuts.
X
\
Seal the space between the floor and the toilet using
silicone caulking. Let cure for 24 hours before using
the toilet (Figure 14).
If the toilet is not level, repeat steps 2 and 3 until the
toilet is level.
When complete, proceed to the "Toilet Seat Installation"
section.

Toilet Seat Installation

To insure that your installation proceeds smoothly, please
read these instructions carefully before you begin. Carefully
unpack the seat and assemble kit.
ALL INSTALLATON PROCEDURES MUST COMPLY WITH
All APPLICABLE LOCAL PLUMBING & BUILDING CODES.
X
X
Carefully remove the old seat (if applicable).
X
Y
Install the toilet seat onto the ceramic bowl (as
illustrated to the right) using the supplied hardware.
X
Z
Center the toilet seat over the ceramic bowl, then
tighten each mounting screw with a slot head
screwdriver (Figure 15).
X
[
Snap hinge covers down over the mounting screws
to complete installation.
When complete, proceed to the "Water Connections"
section.
Installation and Operation
www.jacuzzi.com
Toilet
Shim
(Commercially
Available)
Floor
Figure 13
Toilet
Caulking
(Commercially
Available)
Floor
Figure 14
Screw
Washer
Slot
Washer
Hinge
Cover
Hinge
Gasket
Conical
Washer
Nut
Toilet
Bowl
Figure 15
Page 9