Dometic S5 Instrucciones De Montaje Y De Uso página 7

S5
See fig. 7
A
NOTICE!
Observe the sealant manufacturer's instructions.
➤ Seal the outer frame with a flexible, non-hardening butyl sealant
(e.g. SikaLastomer 710).
See fig. 8
➤ Place the outer frame in the center of the wall section in terms of height and
width.
➤ Press the outer frame slightly onto the wall so that the sealant compound spreads
out.
➤ Position the inner frame into the support strips on the outer frame, and screw it on
with the appropriate mounting screws (1).
Only slightly tighten the screws by hand
(max. tightening torque 3 Nm).
➤ Check that the roller blinds can move freely.
If the roller blinds cannot be moved freely, loosen the screws (1) a little.
➤ Cover the screw holes with the ventilation grilles (2).
➤ Remove the protective film from both sides of the acrylic glass.
I
NOTE
If the protective film is exposed to sunlight for too long, it cannot be
taken off without leaving a residue.
➤ After installing, check that the wall window works properly.
➤ If necessary, enter the new weight into the vehicle documents.
EN
Install S5
7