Pair Remote - Serta Motion Custom II Manual De Instrucciones

pair remote

The original remote that comes in the box is already paired to the bed base.
In the event that the remote is not paired with the base, follow the steps below.
STEP 1
Remove back cover from remote
control . Remove and replace
batteries .
STEP 2
Double click the button on the
Power Down Box (this will not
cause the base to move) . The
light will illuminate .
If the Power Down Box is not available- Press Reset button on control box . Pairing LED light on control box will illuminate . Press and hold
button on the back of the remote, the button will begin to blink. Both lights will become continuous and then simultaneously turn off.
No further action is required.
STEP 3
Press and hold button on the back of the remote .
The light will begin to flash then become a
continuous solid light .
STEP 4
Both lights on the Power Down Box and the
Remote will be continuous, then simultaneously
turn off. Replace back cover of the remote.
The remote is now paired with the base .
19