Rotel RA-05 SE Manual De Instrucciones página 10

Amplificador integrado estereofónico
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 25
10
Troubleshooting
Most difficulties in audio systems are the result of incorrect connections,
or improper control settings. If you encounter problems, isolate the area
of the difficulty, check the control settings, determine the cause of the fault
and make the necessary changes. If you are unable to get sound from the
RA-05 SE, refer to the suggestions for the following conditions:
Power Indicator Is Not Lit
The Power Indicator and the basic items in the Display window should be
lit whenever the RA-05 SE is plugged into the wall power outlet and the
Power button is pushed in.If it does not light, test the power outlet with
another electrical device,such as a lamp. Be sure the power outlet being
used is not controlled by a switch that has been turned off.
Fuse Replacement
If another electrical device works when plugged into the power outlet,
but the Power Indicator of the RA-05 SE does not light when plugged into
the same outlet and the Power Switch is pushed in, it indicates that the
internal power fuse may have blown. If you believe this has happened,
contact your authorized Rotel dealer to get the fuse replaced.
No Sound
Check the signal source to see if it is functioning properly. Make sure
the cables from the signal source to the RA-05 SE inputs are connected
properly. Be sure the Listening Selector is set to the proper input. Check
the wiring between the RA-05 SE and the speakers.
RA-05 SE Stereo Integrated Amplifier
Specifications
Continuous Power Output
(20-20 kHz, < 0.03%, 8 ohms)
Total Harmonic Distortion (20Hz-20kHz)
Intermodulation Distortion (60 Hz : 7 kHz, 4:1)
Frequency Response
Phone input
Line Level Inputs
Damping Factor (20-20,000 Hz, 8 ohms)
Input Sensitivity / Impedance
Phone input
Line Level Inputs
Input Overload
Phone input
Line Level Inputs
Premp Output / Impedance
Tone Controls - Bass / Treble
Signal to Noise Ratio (IHF "A" weighted)
Phone input
Line Level Inputs
Power Requirements
Power Consumption
Dimensions (W, H, D)
Panel Height
Weight (net)
All specifications are accurate at the time of printing.
Rotel reserves the right to make improvements without notice.
Rotel and the Rotel HiFi logo are registered trademarks of
The Rotel Co, Ltd., Tokyo, Japan.
40 watts/ch
< 0.03% at rated power,
1/2 power or 1 watt
< 0.03% at rated power,
1/2 power or 1 watt
20Hz-15kHz, ±0.3dB
10Hz-40kHz, ±1dB
180
2.5mV / 47 kOhms
150 mV / 24 kOhms
180mV
5V
1V / 470 Ohms
±6 dB at 100Hz / 10kHz
80 dB
100 dB
230 Volts, 50 Hz
220 Watts
17
1
/
" x 2
7
/
" x 13
1
/
"
8
8
2
435 x 72 x 342 mm
60 mm / 2
3
/
"
8
5.9 kg, 13lbs

Publicidad

Tabla de contenido
loading

Tabla de contenido