Clean Debris Off Mower; Storage Procedure - Snapper 7800979-00 Manual Del Operador

Clean Debris Off Mower

WARNING
Amputation Hazard
• DO NOT attempt any maintenance, adjustments or
service with engine and blade running.
• STOP engine and blade.
• Disconnect spark plug wire and secure away from spark
plug.
Burn Hazard
• Engine and components are HOT.
• Avoid serious burns, allow sufficient time for all
components to cool.
Laceration Hazard
• Wear heavy leather gloves when handling or working
around cutting blades.
• Blades are extremely sharp and can cause severe
injury.
1. Clean dirt and debris from the top of the mower deck.
2. Clean any debris buildup on or around the engine, etc.
While cleaning, check components for wear or damage.
Replace worn or damaged components immediately.

Storage Procedure

WARNING
Amputation Hazard
• DO NOT attempt any maintenance, adjustments or
service with engine and blade running.
• STOP engine and blade.
• Remove battery (if equipped).
Burn Hazard
• Engine and components are HOT.
• Avoid serious burns, allow sufficient time for all
components to cool.
Laceration Hazard
• Wear heavy leather gloves when handling or working
around cutting blades.
• Blades are extremely sharp and can cause severe
injury.
Prepare the mower for end-of-season storage as follows:
1. Disconnect the spark plug wire and secure away from the
spark plug.
2. Drain the fuel tank and let the engine run until all fuel is
out of the carburetor.
Note: If using a fuel stabilizer, there is no need to drain the
fuel tank. See Storage - Fuel System.
3. Use a brush or compressed air to remove loose debris,
then use a damp cloth to wipe down the unit.
4. Tilt the mower up on its rear wheels and inspect the
underside of the deck. (Do not tilt the mower with the
18
spark plug or carburetor down.) Scrape away stubborn
accumulation of grass with a putty knife and/or wire
brush.
5. Lubricate all exposed metal with a light coating of oil to
prevent corrosion.
6. Carefully fold the handles, flexing the control cables to
prevent cable damage.
7. Store the mower in a shed or other dry area, protected
from weather.
NOTICE Do not stand unit on end.
Storage - Fuel System
Fuel can become stale when kept in a storage container for
more than 30 days. Each time you fill the container with fuel,
®
add STA-BIL 360° PROTECTION™ to the fuel as specified
by the manufacturer's instructions. This keeps fuel fresh and
decreases fuel-related problems or contamination in the fuel
system.
It is not necessary to drain fuel from the engine when STA-
®
BIL 360° PROTECTION™ is added as instructed. Before
storage, turn the engine ON for 2 minutes to move the fuel
and stabilizer through the fuel system.
Service
WARNING
Amputation Hazard
• DO NOT attempt any maintenance, adjustments or
service with engine and blade running.
• STOP engine and blade.
• Disconnect spark plug wire and secure away from spark
plug.
Burn Hazard
• Engine and components are HOT.
• Avoid serious burns, allow sufficient time for all
components to cool.
Laceration Hazard
• Wear heavy leather gloves when handling or working
around cutting blades.
• Blades are extremely sharp and can cause severe
injury.
Check Grease Level in Transmission
1. Remove the transmission fill plug (A, Figure 20). Roll the
machine forward or backward while looking down into the
plug hole.
2. If liquid grease is not visible on the input gear (the small
gear below the plug hole), add an amount, to cover the
gear, of Snapper "00" grease.
Note: Snapper "00" grease (Part No. 7029443) is available at
your dealer.
Note: Do not spill grease or oil onto the surface of the drive
disc (A, Figure 21).
www.snapper.com