Countertop Requirements
9
WARNING
To reduce the risk of ignition of surrounding
combustible materials, install at least 1¼"
(30 mm) from both sidewalls and at least 2"
(50 mm) from the rear wall.
The countertop must be level and horizontal. The
stability of the countertop must be maintained after the
cut-out has been made.
8
Installation Procedure
Install Appliance
9
WARNING
Before you plug in an electrical cord or turn on
power supply, make sure all controls are in the
OFF position.
1
Mark the center of the recess exactly. Fit the long
mounting rail to the front, the short mounting rail to
the rear of the recess. Make sure the lugs of the
mounting rails lie on the worktop. The center
marking on the mounting rail must be precisely
flush with the center marking of the recess.
Note: when fitting the appliance in a stone
countertop glue on the mounting rails with a
temperature-resistant two-component adhesive
(metal on stone).
2
Lower the appliance into the cut-out. The snap-in
pins on the appliance must lie exactly on the catch
springs. Firmly press the appliance into the cut-out.
The pins on the appliance must snap into the catch
springs.
I n s t a l la t i o n P r o c e d u r e